The module crash+ has been adapted to current changes in the Machinery Directive.
From version crash + V / 2, the module has two relays, a „log- in relay“ and a „crash relay“.
The log in relay is switched on and off via transponder and replaces the mechanical ignition lock.
The crash relay is activated only in case of a crash and can perform the vehicle-specific shut down.
Double socket relay with connection cable
Relay socket version 2
E006-120
That means in detail:
Important:
If the presence detection is used together with radio data transmission, there must be a distance of at least 70 cm between the radio module and the presence detection in order to rule out interference
The circuit board between the WiFi module Matchport
b/g or b/g Pro and the motherboard was replaced by a new interface board.
The remote sensor is connected to the underside of the interface board (connector).
The connection of the programming socket (from the motherboard)
is also inserted on the underside of the interface board.
The interface board is only available as an active version.
During configuration with the service software “IP-WiFi” must be ticked.
Learning while driving
With a simple click, the „Start test-drive“ starts and after a short time, the first values are transferred directly into an existing or new profile.
Information can also be collected over a longer period of time – without any „crash-tripping“.
Evaluation and analysis
The logbook shows the level and strength of a crash.
Individual setting possibilities allow a variety of measures - from registering the crash in the logbook,
to being alerted by a flashing light up to the shutdown of the vehicle anything is possible.
The levels and values can then be conveniently compared and evaluated in Excel.
Installation is fast and easy
The acceleration sensor and the seismic microphone are quickly mounted and operational with plug connections.
The initial configuration is done via the Easykey manager and makes the vehicle immediately available.
Changes to the settings can then be made conveniently from your PC.
Measurements | 120 x 80 x 55 mm |
Weight without connection cable | 620 g |
Housing | Protection class IP54 |
Housing | with 4 screws possible |
Measurements of programming socket | round 28 x 40 mm |
Temperature range | -10 bis +65° C |
Relays | (potential-free), |
Lenght of connection cable | Approx. 3 m |
On and off switch | Via user transponder, |
Power supply | 10 – 30 V |
Electricity consumption | < 100 mA |
Transponder response range | Approx. 0 – 30 mm |
Programming of user data | Via (RS 232) serial interface |
Programming cable | Length approx. 1,5 m |
Data retention | battery backed (approx. 5 years battery life) |
Certificates | BZT |
Measurements of sensor | 80 x 75 x 55 mm |
Length of connector cable | 4 m |
Housing of sensor | Protection class IP 65 |
Length of microphone cable | Standard 2 m (max. 4 m) |
Domnick+Müller GmbH+Co. KG Max-Planck-Straße 11 D-61381 Friedrichsdorf | BESTELLUNG SUPPORT HOMEPAGE |
---|