EKM-100 Technical description basic
Inroduction
The module variant basic is a compact version for use in vehicles and machinery and wherever an access authorization is required.
Upgrading this system with Wi-Fi, Bluetooth and Crash Sensor is possible.
With the mobile Easykey software the basic unit can be administered comfortably via Wi-Fi, Bluetooth, Easy Point or cable.
The system is expandable with numerous accessories.
Motherboard basic
Scheme
Circuit diagram basic
Connector assigment
Reay socket Version 1
(Not suitable for crash+)
E006-014
Fitting manual
- Define installation point
(if necessary make a bracket). - Install the module and secure it with
at least 2 screws . - Before connecting to the mains the maximum
switching current must be measured.
Note: Relay contacts may only be loaded with
a maximum of 60 Watt. - If the power is greater than 60 watts, an additional
power relay must be used. - Relay contacts to be connected in series
with the load. - For the power supply of the module insure that
an 1 A slow fuse is fitted with the plus connection
see diagram, page 3). - If a seat switch (SEAT) is used, the seat-contact
bridge on the mother board must be wired up
(depending on the polarity). - If no seat switch (Seat) is used, the yellow cable
must be wired to Negative (-). The seat-contact
bridge (Seatkont) is also to be wired to Negative (-). - If Presence Detections is used, wire the seat-contact
bridge (Seatkont) to Negativ (-)
Important:
If the presence detection is used together with radio data transmission, there must be a distance of at least 70 cm between the radio module and the presence detection in order to rule out interference
Technical data
Measurements | 120 x 80 x 55 mm |
Weight without connection cable | 490 g |
Housing | Protection class |
Mounting | with 4 screws possible |
Measurements of programming socket | round 28 x 40 mm |
Temperature range | -10 to +65° C |
Relay | (potential-free), |
Lenght connection cable | Approx. 3 m |
On and off switch | Via user transponder, |
Power supply | 10 – 30 V |
Electricity consumption | < 100 mA |
Transponder response range | Approx. 0 – 30 mm |
Programming of user data | Via (RS 232) serial interface |
Programming cable | Length approx. 1,5 m |
Data retention | battery backed (approx. 5 years battery life) |
Certificates | BZT, CE |
Trouble shooting
MUSS NOCH ÜBERARBEITET WERDEN
Domnick+Müller GmbH+Co. KG Max-Planck-Straße 11 D-61381 Friedrichsdorf | BESTELLUNG SUPPORT HOMEPAGE |
---|
Domnick+Müller GmbH + Co. KG
Max-Planck-Straße 11
D-61381 Friedrichsdorf
BESTELLUNG
bestellung@mobileeasykey.de
SUPPORT
khd@mobileeasykey.de
www.mobileeasykey.de