Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Image Modified


Table of Contents

...

  • The grey cable of the Easykey is the positive polarity of the coil of the external electronic load relay.
    With this external relay the ignition switch can be replaced.
  • The white cable of the Easykey is the positive polarity of the coil of the external crash load relay.
    With this external relay, in the event of a crash, any function can be switched.
  • The output load is max. 200mA each (for the log-in and crash relay on the circuit board).
  • With an input larger than 30 Volt DC a voltage transformer (Article number E006-010) must be installed.
  • Note: The relays (log-in and crash relay on the circuit board) switch the input voltage “UB Easykey”
    (e.g. 12 V or 24 V), therefore the external load relays must run the appropriate voltage.

Important:

If the presence detection is used together with radio data transmission, there must be a distance of at least 70 cm between the radio module and the presence detection in order to rule out interference


Circuit board WiFi

The circuit board between the WiFi module Matchport

...

Changes to the settings can then be made conveniently from your PC.



Technical data


Measurements120 x 80 x 55 mm
Weight without connection cable620 g
Housing

Protection class IP54
Industrial quality

Housing

with 4 screws possible
max. diameter of screw 4 mm

Measurements of programming socket

round 28 x 40 mm
Drill diameter 20 mm

Temperature range-10 bis +65° C
Relays

(potential-free),
maximum load 60 Watt

Lenght of connection cable

Approx. 3 m

On and off switch

Via user transponder,
Display via module (LEDs)

Power supply10 – 30 V
Electricity consumption< 100 mA
Transponder response rangeApprox. 0 – 30 mm
Programming of user data

Via (RS 232) serial interface
Via Easy Point (no initial set up!)
Optional WiFi or Bluetooth

Programming cableLength approx. 1,5 m
Data retentionbattery backed (approx. 5 years battery life)
Certificates

BZT
CE

Measurements of sensor80 x 75 x 55 mm
Length of connector cable4 m
Housing of sensorProtection class IP 65
Length of microphone cableStandard 2 m (max. 4 m)




























Domnick+Müller GmbH+Co. KG

Max-Planck-Straße 11

D-61381 Friedrichsdorf 

BESTELLUNG

bestellung@mobileeasykey.de

SUPPORT

khd@mobileeasykey.de

HOMEPAGE

www.mobileeasykey.de

...